|
Balsa used to hold paper tube in place that the elevator wires will go in |
|
After hole has been drilled and sanded to look a little better |
|
Holding one in place w/o the tube |
|
glued in with the tube installed (you can see the Rx tubes on the top (really bottom of fuse) |
|
Tailwheel plate installed (can't see it, but it is built up on the backside to accomodate the RC Blimp titanium tailwheel. |
|
Self correcting SWB tray being fitted in position where it will go |
|
Adding more bracing to it to make it stay put |
|
Putting the bottom sheeting on (using whatever I have to make sure the sides stay straight) |
|
Fronts are already glued in (missed the pics on that) |
|
After glue has dried and it is shaped and sanded |
|
Some CF rings for the cans |
|
Another pic |
|
Side shot with the top sitting in place |
|